Prochem Blazer GT Manuale Utente Scaricare il pdf (Pagina 11)

SOLUTION TEMPERATURE

CONTROL

SOLUTION PRESSURE

REGULATOR

SOLUTION OUTLET

CHEMICAL

CHECK

VALVE

VACUUM

LUBRICATION

LUBRICATE

WITH VACUUM

INLETS SEALED

SOLUTION

SCREEN

WARM HOT

LUBRICATE REGULATOR SEALS

EVERY 50 HOURS.

RECOMMENDED LUBRICANT:

SYNCO SUPER LUBE

STARTING

SHUTDOWN AND DAILY MAINTENANCE

CONDENSED OPERATING INSTRUCTIONS

STARTING

CONDENSED OPERATING INSTRUCTIONS

1. CONNECT WATER HOSE TO WATER INLET CONNECTION AND TURN ON WATER

SUPPLY.

2. CONNECT SOLUTION AND VACUUM HOSE TO THE DESIRED CLEANING TOOL

AND TO THE CONSOLE.

3. PULL OUT THROTTLE 3/4 INCH.

4. PULL OUT ENGINE CHOKE. TURN WASTE PUMPOUT SWITCH TO OVERRIDE

POSITION AND TURN IGNITION SWITCH TO START.

5. PUSH IN

CHOKE AND RELEASE OVERRIDE SWITCH AFTER ENGINE HAS

STARTED.

6. INSERT CHEMICAL INLET AND PRIME HOSES INTO CHEMICAL CONTAINER.

7. ROTATE CHEMICAL VALVE TO PRIME AND

OW THROUGH

THE CHEMICAL CIRCUIT. AFTER ALL

AIR BUBBLES

HAVE BEEN REMOVED, TUR

N THE CHEMICAL VALVE TO THE ON

POSITION.

8. TURN THE CHEMICAL VALVE TO RUN, OPEN THE VALVE ON THE CLEANING

TOOL AND SET THE CHEMICAL FLOW VALVE TO THE DESIRED CHEMICAL

FLOW RATE WHILE OBSERVING THE FLOW METER.

9. SET THROTTLE TO THE DESIRED OPERATING SPEED.

10. FOR QUICK HEAT-UP REFER TO THE OPERATING INSTRUCTION MANUAL.

1. TURN CHEMICAL VALVE TO THE OFF POSITION, AND REMOVE THE

VACUUM HOSE.

2. ALLOW THE UNIT TO RUN FOR 2 MINUTES WITH THE VACUUM HOSE

DISCONNECTED TO REMOVE MOISTURE THEN SPRAY A WATER

DISPLACEMENT/LUBRICANT INTO THE VACUUM LUBRICATION CUP.

THIS WILL PREVENT CORROSION DUE TO MOISTURE.

3. PUSH THE THROTTLE “IN” TO THE IDLE POSITION AND OPEN THE

TEMPERATURE BYPASS VALVE FOR 2 MINUTES ALLOWING THE UNIT

TO COOL DOWN.

4. TURN OFF IGNITION SWITCH.

5. DISCONNECT ALL HOSES AND TOOLS.

6. DRAIN WASTE TANK INTO AN APPROVED SOURCE AND CLEAN THE

STRAINER BASKET AND WASTE TANK FILTER.

ALL

OW CHEMICA

LTO

Safety

Safety Labels

The following WARNING LABELS are found on your cleaning unit. These labels point out important Warnings and

Cautions which should be followed at all times. Failure to follow warnings and cautions could result in fatality,

personal injury to yourself and/or others, or property damage. Follow these instructions carefully! DO NOT remove

these labels.

NOTE: If at any time the labels become illegible, promptly replace them.

86317260 BLAZER GT

Warning Label

P/N 86186520

Caution Label

P/N 86186530

Lower Front Panel Decal

with warning labels

P/N 86316190

Caution Label

P/N 86352580

Installation on vehicle fuel door.

CAUTION

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 131 132

Commenti su questo manuale

Nessun commento

Prochem Blazer GT Manuale Utente Pagina 11

Commenti su questo manuale

Prodotti e manuali riguardandi Apparecchiature Prochem Blazer GT